Leather Headrest Install Instructions

Remove the Rear Seat Trim Piece (just pops right off) and remove the 4 screws that hold the back place in place:

Place the headrest in place and arrange the straps as shown in the image below:

At this point you can use a nail or scribe to make a small hole in the leather strap to make it easier to guide the screw through during re-assembly.

Holding the straps in place, replace the basket, and reinstall the 4 screws. You may need to pull on the straps lightly to ensure a tight fit, or to adjust the headrest so that it sits properly in place (put the seat back and make sure that the bottom of the headrest is level before finishing assembly):

Replace the trim piece on the back of the seat and enjoy driving with the ability to comfortably rest your head against the seat back.